Electrical Connection - DITEC BIS 1 O-V Manuel D'installation Et D'entretien

GB
3.8 BIS T TIE ROD POSITION
BIS 1 T right opening (fig. 11)
BIS 1 T left opening (fig. 12)
BIS 2 T (fig. 13)
To adjust cable tension, tighten or loosen rods [R] and [S] in
equal measure.
Adjust the overlap of the wing as follows:
- Bring door wings in closing position.
- The external door [T] wing must be in the stop position.
- Loosening [R] and pulling [S], the door wing [U] moves
towards [S] (overlap increases).
- Loosening [S] and pulling [R] , the door wing [U] moves
towards [R] (overlap decreases).
4.

ELECTRICAL CONNECTION

Electrical wiring and starting are shown in the installation manual
of Control Panel EL16.
5. MAINTENANCE PROGRAM (each 6 month)
Power off 230 V~ and batteries:
- Clean and lubricate the moving components (especially
the inside edges of the guide along which the carriages
run).
- Check the tension of the belt.
- Clean sensors and photocells.
- Check for the stability of the automatism and check that all
the screws are tightened all the way.
- Check that the wings are correctly aligned, that stops are
properly positioned and that the lock has been correctly
fitted.
Power on 230 V~ and batteries:
- Check that the lock/release system is working properly.
- Check for the stability of the door and that the movement is
steady, without friction.
- Check the operation of all command functions.
- Check the functioning of the photocells.
- Check that the forces generated by the door comply with
legal requirements.
ATTENTION: For spare parts, see the spares price list.
DITEC S.P.A - IP1653 - BIS
All right reserved
All data and specifications have been drawn up and checked
with the greatest care. The manufacturer cannot however take
any responsibility for eventual errors, ommisions or incomplete
data due to technical or illustrative purposes.
16