Technical Data; Electrical Connections - DITEC Arc B Manuel D'installation Et D'entretien

1 TECHNICAL DATA

Power supply
Absorption
Motor power
Geared motor torque
Speed
Intermittence
Temperature
Degree of protection
Application
Recommended
dimensions
Limit
dimensions
2. REFERENCE TO ILLUSTRATIONS
2.1 Standard installation references (fig. 1)
ATTENTION: Only use DITEC's safety devices and accessories for installation.
[1] Radio
[2] Flashing light
[3] Key selector
2.2 Accessories (fig. 2):
(fig. 3):
2.3 Geared motor references
[8]Gate attachment bracket
[9]Housing
3. INSTALLATION
3.1 Preliminary checks
Check that the structure is sufficiently sturdy and that the hinge pivots are properly lubricated. Provide an opening
and closing stop.
3.2 Installing the geared motor
- Remove the geared motor from its package. Attention: Cover [9] is not secured.
- Disassemble the reduction gear from the fixing plate [10].
- Attach plate to gate column according to measurements specified in figures 14 and 15, depending on type of
installation.
- Assemble the geared motor on the fixing plate following fig. 6 for the fitting onto the left pier, inside view, and
fig. 7 for fitting onto the right pier, inside view.
- Release the geared motor (see operating instruction).
- Attach articulated arms and gate attachment bracket as shown in figures 8 and 9 and according to
measurements specified in figures 14 and 15.
Attention: bring the leaf to the stop line, align the arms by means of holes [D] as shown in the detail in fig. 8. The articulations
on the arms should be lubricated and the screws tightened in such a way as not to block arm movement.
- Drill the cover Ø 14 near release shaft [12] (there are two drilling templates [11] in side the cover) and insert
the rubber plug (supplied). Attach the cover to the geared motor.

4. ELECTRICAL CONNECTIONS

4.1 Connect the geared motor ARC B as shown in fig. 10 or in fig. 11.To reverse the direction of rotation,
exchange the motor phases (U with V and/or X with Y).
4.2 Connect the geared motor ARC BH as shown in fig. 12a, 12c (1 wing) or in fig. 13b, 13d (2 wings). To
reverse the direction of rotation, exchange the motor phases (36 with 34 and/or 33 with 31).
DITEC S.P.A - IP1725 - ARC
ARC B
230 V~ 50 Hz
1.2 A
100 W
300 Nm
22s / 90°
S2=15min,S3=25%
-15 °C / +50 °C (see NIO for LogicC22/C22S)
m
5
4
3
2
1
100 300
Service life 3
[4] Connect power supply to an type-approved
omnipole switch with a contact opening
gap of no less that 3 mm (not supplied by
us)
ARC FB Adjustable stop
ARC PL Plate for front attachment of geared motor
[10] Attachment plate
[11] Drilling templates for release key
IP54
m
kg
500
Service life 4
10
ARC BH
24 V
3 A
24 W
150 Nm
15÷18s / 90°
S2=30min,S3=50%
5
4
3
2
1
kg
100 300 500
[5] Electric board
[6] Geared motor ArcB
[7] Photocells
BOX FC1 Limit switch
[12] Release shaft