RIB KIT PREMIER 24V Mode D'emploi page 29

F
IXING THE OPERATOR TO THE PILLAR (D)
In order to carry out a proper installation of the operator, it is necessary to comply with the geometry measurement shown in the tables in Pic. 6 and 8.
X
D
A
SSEMBLING DRIVE ARM WITH THE ANTI-
THEFT LOCKING DEVICE (E)
Assemble the arms as shown in Pic. 5.
Caution: Once the screws V and W have been thoroughly
tightened (Pic. 5) unscrew them for half a turn, in order to
guarantee a free movement of the arm.
After assembling the arm, unlock the motor and fix the arm
to the motor with the supplied screw and M10 washer.
With the gate in closing position and the motor at rest, the
anti-theft lock (E) keeps the gate leaves securely closed
and prevents anybody from forcing the gate leaves open.
F
IXING THE DRIVE ARM WITH THE ANTI-THEFT LOCKING DEVICE (E)
Unlock the operator.
Caution: start the operation with the gate in closing position. Straighten the levers until the anti-theft lock (E Pic. 5) is engaged and stressed. Move the
levers back a little bit just enough to avoid keeping the anti-theft locking in working position (stressed) every time the gate will close.
α°
A max A max*
90 140 190
90 200 200
90 205 205
90 225 225
90 240
95 0 0
100 0 0
105 0 0
110 0 0
A max* - In case only one mechanical stopper is used in closing (Pic. 8)
13
X B I T sec
20
60 130 300
19
70 140 270
18
80 150 230
16
90 160 135
110 180 0 15
70 140 284 18
90 160 302 19
110 180 315 19
155 225 322 19
E
B
X
A
α
I
V
W
DRL8x17I
DRL10x20I
DRG6I
DRL8x17I
DRL8x17I
G G
B B
4
5
6