Motorola CLK446 Mode D'emploi page 31

3. For both the Source and Target radios, to power
up in Cloning mode, press the INFO button and
Power button simultaneously.
The cloning icon displays on the LED screen.
4. Press the Volume Control Button (+/–) to
enable cloning then, press PTT button to
confirm.
The cloning icon "C" flashes on the display.
All data which can be customized will be
transmitted from the Source Radio to the Target
Radio via the cloning cable.
5. If cloning is successful, the radio emits a pass
tone and the cloning "C" icon stops flashing.
If there is an error during cloning, the "E" icon
flashes on the display. Reset the radio and
reinitiate cloning.
6. Once the cloning process is completed, turn the
Radios OFF and ON again to exit "Clone" mode.
What To Do If Cloning Fails
The display flashes "E" indicating that the cloning
process has failed. In the event that the cloning fails,
perform each of the following steps before attempting
to start cloning process again:
1. Ensure that the batteries on both radios are fully
charged.
2. Check the cloning cable connection on both
radios.
3. Ensure that the battery is engaged properly on
the radio.
4. Ensure that there is no debris in the charging
tray or on the radio contacts.
5. Ensure that the Source radio is in cloning mode
and the Target radio is turned on.
6. Ensure that the two radios are both from the
same frequency band, same region and have
the same transmission power.
When ordering the CPS Cloning Cable Kit, please
refer to P/N# HKKN4028_. For more information
about the accessories, refer to "Accessories" on
page 39.
29
English