Keysight Technologies U1273A Guide De L'utilisateur page 87

Measuring Temperature
Do not connect the thermocouple to electrically live circuits. Doing so will
WARNING
potentially cause fire or electric shock.
Do not bend the thermocouple leads at sharp angles. Repeated bending
CAUTION
over a period of time can break the leads.
The multimeter uses a type-K (default setting) temperature probe for measuring
temperature. To measure temperature, set up your multimeter as shown in
Figure
Table 2-16 Rotary switch position allowing temperature measurements
Legend Defaul t function
Capacitance measurement
Probe the test points, and read the display. The primary display normally shows
temperature or the message OL (open thermocouple). The open thermocouple
message may be due to a broken (open) probe or because no probe is installed
into the input jacks of the multimeter.
Figure 2-28
Keysight U1273A/U1273AX User's Guide
2-29.
Temperature display
Making Measurements
is pressed
Function when
Temperature measurement
2
87