Keysight Technologies U1273A Guide De L'utilisateur page 110

3 Multimeter Features
Capturing Maximum and Minimum Values (MaxMin)
The MaxMin operation stores the maximum, minimum, and average input values
during a series of measurements.
When the input goes below the recorded minimum value or above the recorded
maximum value, the multimeter beeps and records the new value. The elapsed
time since the recording session was started is stored and shown on the display at
the same time. The multimeter also calculates an average of all readings taken
since the MaxMin mode was activated.
From the multimeter's display, you can view the following statistical data for any
set of readings:
– REC MAX: highest reading since the MaxMin function was enabled
– REC MIN: lowest reading since the MaxMin function was enabled
– REC AVG: average or mean of all readings since the MaxMin function was
– REC NOW: present reading (actual input signal value)
1 Press
2 Press
Figure 3-4
3 The elapsed time is shown on the secondary display. Press
110
enabled
to enable the MaxMin operation.
again to cycle through the MAX, MIN, AVG, or NOW (present)
input values.
MaxMin display
recording session.
Keysight U1273A/U1273AX User's Guide
to restart the
Dual
Exit