Publicité
Les langues disponibles
Les langues disponibles
1
Introduction
Table 1-5
Keypad functions (continued)
Legend
Measures the frequency for the current or
voltage measurement.
– Press
(Hz), pulse width (ms), and duty cycle (%)
measurements.
– In duty cycle and pulse width
measurements, press
between the positive or negative edge
trigger.
– Press
this mode.
42
Function when pressed for:
Less than 1 second
to scroll through the frequency
to switch
Dual
Exit
for more than 1 second to exit
Dual
Exit
More than 1 second
Starts and stops the Data Logging.
– If data logging is set as HAND (manual
data logging), pressing
than 1 second will log the present
reading into the memory. The display will
return to normal after a short while (≈ 1
second). To manually log another
reading, press
than 1 second.
– If data logging is set as AUTO
(automatic data logging), pressing
for more than 1 second will enter
the automatic data logging mode, where
data is logged at the interval defined in
the multimeter's setup.
– If data logging is set as TRIG (event data
logging), pressing
second will enter the event data logging
mode, where data is logged each time a
triggering condition is satisfied.
– Press
for more than 1 second to
exit the automatic or event data logging
mode.
Keysight U1273A/U1273AX User's Guide
Learn more
for more
again for more
page 100
and
page 91
for more than 1
on:
Publicité
