Keysight Technologies U1273A Guide De L'utilisateur page 24

1 Introduction
1 Open the battery cover. Lift the tilt stand, loosen the screws with a suitable
2 Insert the battery. Observe the proper battery polarity. The terminal ends of
3 Close the battery cover. Place the battery cover back in its original position
Figure 1-1
The battery level indicator in the lower left-hand corner of the display indicates
the relative condition of the batteries. Replace the batteries as soon as possible
when the low battery indicator (
24
Phillips screwdriver, and remove the battery cover as shown in
each battery are indicated inside the battery compartment.
and tighten the screws.
1
3
Installing the batteries
2
) is shown.
↔
Keysight U1273A/U1273AX User's Guide
Figure 1-1.