Keysight Technologies U1273A Guide De L'utilisateur page 146

4 Multimeter Setup Options
4 Press and hold
Changing the battery type
If you are using rechargeable batteries to power your multimeter, change the
battery type from PRI to SEC for the multimeter to accurately reflect the battery
capacity indication.
Parameter
BATTERY
To change the battery type:
1 Press
2 Browse to Menu 6 > BATTERY, and press
3 Use the arrow keys to change the battery type.
4 Press
5 Press and hold
Enabling the filter
There are two Filter (
– In AC/AC+DC measurement mode, the Filter works as a low pass filter and
– In DC measurement mode, the Filter will block AC signals
Only one of the two filters can be in the signal path at any point in time. The
possible scenarios are:
– Only the AC Low Pass Filter is enabled
– Only the DC Filter is enabled
– No Filter in the signal path
146
multimeter will beep once and return to the first setup menu page. Or,
alternatively press
Range
PRI or SEC
for more than 1 second to enter the multimeter's setup menu.
Setup
to save your changes (or press
until the multimeter restarts to return to normal operation.
Setup
attenuates signals with frequencies of more than 1 kHz
for more than 1 second to perform the reset. The
to discard your changes.
) options within the design of the multimeter:
Keysight U1273A/U1273AX User's Guide
Defaul t setting
PRI
edit the value.
to discard your changes).