Publicité
Les langues disponibles
Les langues disponibles
3
Multimeter Features
Performing event logs (TRIG)
Ensure that TRIG is selected as the data logging option in the multimeter's setup.
Event logs are used only with the following modes:
– TrigHold and AutoHold
– MaxMin recording
– Peak recording
Event records are triggered by the measured signal satisfying a trigger condition
set by the measurement function used in the following modes:
Table 3-3
Event log trigger conditions
Modes
TrigHold
AutoHold
MaxMin
Peak
Start the event log mode
1 Select one of the four modes stated in
2 Press
Subsequent readings are automatically recorded into the multimeter's memory
every time the trigger condition specified in
118
(page
(page
112)
Trigger cond ition
The input signal value is recorded:
Each time
When the input signal varies more than the variation count.
When a new maximum (or minimum) value is recorded. The average and present
readings are not recorded in the Event log.
When a new peak (maximum or minimum) value is recorded.
for more than 1 second to start event log mode.
and the log entry number are displayed at the right of the display.
(page
114)
110)
is pressed.
Table
Table 3-3
Keysight U1273A/U1273AX User's Guide
3-3.
is satisfied.
Publicité
