Connecting External Effectors, Output Connectors - Pioneer DJM-700-S Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 28
01_DJM-700_En.book 7 ページ 2007年7月10日 火曜日 午後8時41分
CONNECTIONS

CONNECTING EXTERNAL EFFECTORS, OUTPUT CONNECTORS

Master output
This unit is furnished with balanced output MASTER 1 (supporting
XLR plugs), and unbalanced output MASTER 2 (supporting RCA
plugs).
Using the MASTER ATT switch, adjust the output level to match
the input sensitivity of the power amplifier used.
If the operating panel's MONO/STEREO switch is set to [ MONO ],
the master output will be a monaural combination of L+R
channels.
Booth monitor output
Unbalanced output supporting RCA-type plug. The sound volume
for this output is controlled by the BOOTH MONITOR LEVEL dial,
independently of the master output level setting.
Recording output
These are output connectors for recording, supporting RCA plugs.
Power amplifier
(for booth monitor)
POWER
OFF
ON
1 GND
2 HOT
3 COLD
Power amplifier
(XLR plug input connectors)
Cassette deck
(analog input
recording device)
CH-4
CH-3
BOOTH
REC
PHONO
LINE
PHONO
LINE
L
L
L
R
R
R
MASTER1
R
L
MASTER2
MASTER
R
R
L
ATT.
-6dB -3dB 0dB
MASTER ATT switch
Digital output
This is a coaxial digital output connector, supporting RCA plugs.
The sampling frequency can be set to 96 kHz/24-bit format or
48 kHz/24-bit format to match the connected device.
• Turn power off before changing this switch position.
External effector
Use a cable with Ø6.3 mm phone plugs to connect the DJ mixer's
SEND connectors to the effector's input connectors.
When using an effector with monaural inputs, connect only to the
DJ mixer's L channel output. In this way, the mixed L+R audio
signal will be sent to the effector. In the same way, use a cable with
Ø6.3 mm phone plugs to connect the DJ mixer's RETURN
connectors to the output connectors of the effector.
If the effector has only monaural output, connect to the DJ mixer's
L channel input only. The signal from the effector will be input to
both L and R channels.
When using an external effector, set the effect selector to [ SND/
RTN ].
Power amplifier
(RCA plug input
connectors)
Sampling frequency
selector switch
CH-2
CH-1
PHONO
CD
LINE
CD
L
L
CONTROL
CONTROL
R
R
SIGNAL GND
SEND
RETURN
DIGITAL OUT
L
R
L
(MONO)
(MONO)
fs(Hz)
48k
96k
Digital input AV amplifier
(digital input
recording device)
MIC 2
MIDI OUT
External effector
En
7

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Djm-700-k

Table des Matières