Connecting Inputs - Pioneer DJM-700-S Mode D'emploi

01_DJM-700_En.book 6 ページ ２００７年７月１０日 火曜日 午後８時４１分
CONNECTIONS
Always turn off the power switch and disconnect the power plug from its outlet when making or changing connections.

CONNECTING INPUTS

Pioneer DJ CD players
The audio output connectors of a DJ-type CD player can be
connected to the CD input connectors (channel 1 or 2), or to the
LINE input connectors (channel 1) of the DJM-700-S/DJM-700-K.
Connect the control cord to the CONTROL jack, and set the input
selector switch to [ CD ] or [ LINE ].
Analog turntable
To connect an analog turntable, connect the turntable's audio
output cable to one of the channel 2 to 4 PHONO input
connectors. Set the corresponding channel's input selector switch
to [ PHONO ]. The DJM-700-S/DJM-700-K's PHONO inputs support
MM cartridges.
POWER
OFF
ON
1 GND 2 HOT
3 COLD
Analog turntable
6
En
Input selector switch
CH-4 CH-3
BOOTH REC PHONO LINE PHONO LINE
L L L
R R R
MASTER1
R L
MASTER2
MASTER
R L
ATT.
-6dB -3dB 0dB
Analog turntable DJ CD player
Connect the ground wire from an analog turntable to the
SIGNAL GND terminal of the DJM-700-S/DJM-700-K.
• Note that no PHONO input connector is provided for channel 1.
Connecting other line level output devices
To use a cassette deck or ordinary CD player, connect its audio
output connectors to one of the DJM-700-S/DJM-700-K's LINE
input connectors (channel 1, 3, or 4) or to the CD input connectors
(channel 1 or 2), and set the input selector switch to [ LINE ].
CH-2 CH-1
PHONO CD LINE CD
L L
CONTROL CONTROL
R R
SIGNAL GND
SEND
RETURN
DIGITAL OUT
R L R L
(MONO) (MONO)
fs(Hz)
48k 96k
DJ CD player
MIC 2
MIDI OUT
CD player, etc.
Cassette deck, etc.