Connecting Inputs; Connecting Outputs; Connecting The Power Cord - Pioneer DJM-400 Mode D'emploi

Always turn off the power switch and disconnect the power plug from its outlet when making or changing connections.

CONNECTING INPUTS

Pioneer DJ CD players
Connect a DJ CD player's audio output connectors to one of the
channel 1 to 2 CD input connectors, and connect the player's control
cable to the corresponding channel's CONTROL connector.
Set the connected channel's input selector switch to [CD].
Analog turntable
To connect an analog turntable, connect the turntable's audio output
cable to one of the channel 1 to 2 PHONO/LINE input connectors. Set
the corresponding channel's PHONO/LINE switch to [PHONO], and
set the channel's input selector switch to [PHONO/LINE]. The DJM-
400's PHONO inputs support MM cartridges. Connect the turntable's
ground wire to the DJM-400's SIGNAL GND terminal.
Connecting other devices with line level output
To use a cassette deck or other CD player, connect the component's
audio output connectors to one of the channel 1 to 2 PHONO/LINE
input connectors. Then set the corresponding channel's PHONO/
LINE switch to [LINE], and the input selector switch to [PHONO/LINE].
Microphone
The MIC1 and MIC2 jacks can be used to connect microphones with
Ø6.3 mm phone plugs. Set MIC/AUX switch to [MIC] position.
Auxiliary input connectors
The MIC1 and MIC2 jacks can also be used together as a pair of stereo
line input connectors to connect a component equipped with line
level output connectors. Connect the component's L channel to MIC1
(AUX(L)) jack and the R channel to the MIC2 (AUX(R)) jack. Then set
the MIC/AUX switch to [AUX] (this connection requires the use of
Ø6.3 mm phone plugs).

CONNECTING OUTPUTS

Master output
This unit is furnished with MASTER OUT 1 and MASTER OUT 2
output systems, both of which support the use of RCA plugs.
If the unit's STEREO/MONO switch is set to [MONO], the master
output will be a monaural combination of L+R channels.
MIC/AUX switch
POWER
OFF ON
AC IN
MASTER
OUT
PHONO/LINE switch
Note:
Set switch to [LINE]
except when using
an analog turntable
Cassette deck, etc.
MIC2 MIC1
MONO STEREO AUX(R) AUX(L)
MIC AUX
PHONO
CD
LINE
1 2
L L
LINE PHONO
R R
CONTROL
R L R L
L R
Analog turntable
Headphones
The front panel PHONES jack can be used to connect headphones
with a Ø6.3 mm stereo phone plug.
POWER
AC IN
Power amplifier
Cassette deck, etc.
(analog input recording
component)

CONNECTING THE POWER CORD

Connect the power cord last.
÷ After completing all other connections, connect the accessory
power cord to the AC inlet on the back of the player, then connect
the plug to a standard wall outlet or to the auxiliary power outlet
of your amplifier.
÷ Use only the supplied power cord.
PHONO
CD
LINE
SIGNAL
GND
L
LINE PHONO
R
CONTROL
R L R L
Analog turntable DJ CD player
CONNECTIONS
Front panel
STEREO/MONO switch
MONO STEREO
OFF ON
1 2
MASTER
L
OUT
R
L R R L
Power amplfier
Input selector switches
Microphone 2
Microphone 1
R
L
Electronic instrument,
CD player, etc. (phone
plug connection)
DJ CD player
Headphones
5
<DRB1404>
En