Connecting The Input/ Output Terminals - Pioneer DJM-350 Mode D'emploi

Connecting the input/ output terminals

Rear panel
R L
R L
AUDIO
OUT
CONTROL
USB
Example:
CDJ-350
DJ player
1 To use the fader start function, connect a control cord (page 10).
The fader start function can only be used when connected to a Pioneer DJ player.
2 A portable audio device can be connected using an RCA pin - mini-plug (Ø 3.5 mm) converter cable (page 11).
Front panel
Headphones
Headphones cord
To power outlet
Power cord (included)
AC IN
Audio output section
Audio cable
Control cord 1
To ground To audio
wire terminals output terminals
Analog player
Component, amplifier,
powered speaker, etc.
Audio cable To audio input terminals
Audio input section
MASTER OUT CH-2
1 2 PHONO CD
L L
L L
CONTROL
R R
R R
Ground wire
Audio cable
To audio
output terminals
Portable
Microphone
audio
device
SIGNAL
GND
CH-1 AUX
PHONO CD
L
L
MIC
L L
CONTROL
R R
R
R
Audio cable 2
Microphone
cable
To microphone
7
En