Installation Steps; Care And Cleaning - AVS Ventvisor Deflector Instructions D'installation

Installation Steps

Align the visor with the previously cleaned surface. The flanges of
the visor attach to the surface of the window's chrome trim.
3
Apply pressure along all flanges to ensure adhesion of tape to the trim surfaces.
5
4 Piece Set
The rear visor attaches with the same preparation methods as the front. The visor butts up against the rear
6

Care and Cleaning

• Wash only with mild soap & dry with a clean cloth.
Congratulations!
You have purchased one of the many quality Auto Ventshade™ branded products offered by Lund International, Inc. We take the utmost pride in our
products and want you to enjoy years of satisfaction from your investment. We have made every effort to ensure that your product is top quality in
terms of fit, durability, finish and ease of installation.
Auto Ventshade
™
NOTE: Actual application may vary slightly from illustrations.
edge of the front visor and is aligned on the chrome trim area.
Repeat Steps 1-6 for opposite side.
Lund International, Ventshade Accessories Division
655 Raco Drive, Lawrenceville, GA 30045
800-241-7219 • Fax 770-339-5839 • Visit us at lundinternational.com
© 2010 Lund International, Inc. All rights reserved.
, the Auto Ventshade logo and the AVS
TM TM
Verify proper positioning. With the visor in its final position, remove
remaining tape liner by pulling on free ends.
4
foam tape
PRESS
visor
cross section of visor placement
logo are trademarks of Lund International, Inc.
TM
Page 2 of 2
inside face of
window frame
rubber channel
chrome trim