Mortising Edge Trimming On A Door; Measuring And Tracing Refrences - Virutex FC116U Mode D'emploi

"c"
"H2"
(Figure 9)
22 - FC116U / Operating instructions
"rs"
"H2"
"0"
"c"

11. MORTISING EDGE TRIMMING ON A DOOR

• Place the door vertically and fasten well so that it does not
move. If the door is already mounted on the frame, place wedges
under it to prevent it from moving.

MEASURING AND TRACING REFRENCES

• Place the lock against the door so that the path for the door
knob or handle is at the desired height from the ground "H0"
(Fig. 9) and mark the point "0" (Fig. 9) on the face and edge of
the door.
• Measure the distance "H2" (Fig. 9) from the centre of the
handle to the centre of the box for the lock.
"0"
"c"
"H0"
• Mark the centre "c" of the box for the lock onto the edge
of the door using the tracing template "Pt" (Fig. 9), which
comes with the equipment.
This template has a set of grooves 5 mm apart. You must place
the template onto the edge of the door so that the mark "0" (Fig.
9) is lined up with the groove that corresponds to the measure-
ment "H2" (Fig. 9) made earlier (20 mm in Fig. 9). Now make the
"c" mark (Fig. 9) on the lower edge of the template.
• Trace the upper reference "rs" (Fig. 9) which acts as a
reference for attaching the machine to the door.
To do this, place the lower edge of the tracing template "Pt" (Fig.
9) on the mark "c" (Fig. 9) and mark the point "rs" (Fig. 9) on the
upper edge of the template.
"rs"
"rs"
Pt
"c"
"0"
"c" "H2"