Adjusting The Trimming Length; Adjusting The Trimming Depth - Virutex FC116U Mode D'emploi

H
T
P
F
(Figure 6)
(Figure 7)
(Figure 8)
(Figure 5)
S
R
V
J
W
A
U

9. ADJUSTING THE TRIMMING LENGTH

• Measure the longest point, "H", of the lock box, including any
protuberance it may have (Fig. 5). DO NOT INCLUDE the exterior
decorative face of the lock.
Check that the trimmer is disconnected from the
mains.
• To adjust the machine to the required trimming length "H",
loosen nut "P" (Fig. 6) with key "F" and move screw knob "R" until
the length indicator "S" reaches the desired measurement "H",
then tighten nut "P" in this position.
Be sure to tighten nut "P" (Fig. 6); if not, this
may cause the trimming length adjustment me-
chanism to break.
The centring of the bit over the thickness of the door or the part
to be mortised is automatic if the small plates "J" (Fig. 7) are in
the "0" position on the two clamp vise guides "V" (Fig. 7).
V
A
V
W

10. ADJUSTING THE TRIMMING DEPTH

• Measure the depth "T" (Fig. 5) of the lock box including any
protuberance it may have at the bottom, the thickness of the
exterior decorative face and an additional few centimetres as
allowance.
Check that the trimmer is disconnected from the
mains.
• The trimming depth is controlled by the graduated rule "U"
(Fig. 8), marked in 1 mm divisions. Loosen knob "W" and posi-
tion ring "A" so that the inside face coincides with the required
depth, then tighten knob "W" in this position.
FC116U / Operating instructions - 21