Machine Handling Safety Instructions; Standard Unit; Assembling The Carriage Advance Handle - Virutex FC116U Mode D'emploi

Fig. 1
(Figure 1)

3. MACHINE HANDLING SAFETY INSTRUCTIONS

Ensure that the person who is to use this machi-
ne reads these OPERATING INSTRUCTIONS and
the enclosed GENERAL SAFETY INSTRUCTIONS
LEAFLET carefully and understands them before
starting work.
• Before connecting the machine, ensure that the power supply
voltage corresponds to that indicated on the characteristics pla-
te.
• To change the bit or carry out any other operation close to the
cutting head, disconnect the machine from the mains.
• Use safety goggles when working with the trimmer.
• Do not start the motor if the machine chassis has been re-
moved.
• Check the power supply cable to make sure it does not twist
during use.
• Always start the trimmer using the main switch lever.
• Once the trimmer has been placed on the part to be trimmed,
always move the tool using the carriage advance crank handle.
Never push it by hand or with extraneous tools.
• Ensure that the motor is at a complete standstill before remo-
ving the trimmer from the completed mortise.
• Always use bits of the correct diameter, correctly mounted on
the serrated axis.
• Never use bits that are incorrect, defective or in bad condition.
Use only authentic VIRUTEX bits and spare parts.

4. STANDARD UNIT

The following elements are included in the box:
• Lock mortiser FC116U
• Drilling tool for cylinder and needle UT16I
• Service keys and tracing template
• Detachable height bar in 4 sections and a door limiter.
• Four clamp vise protectors for precise mounted jobs.
• Mortising trimmer bit, 16 mm diameter.
• Operating Instructions and miscellaneous documen-tation.

5. ASSEMBLING THE CARRIAGE ADVANCE HANDLE

Check that the trimmer is disconnected from the
mains.
• Match the rectangular carriage forward handle slot "A" to the
planes of the shaft "B". Fit washer "C" and screw "D", as shown in
(Fig. 1). Tighten screw "D" with spanner "F", to hold the carriage
advance handle in place.
• MAKE SURE NOT TO KNOCK THE SURFACE OF ADVANCE HAND-
LE "A".
FC116U / Operating instructions - 19