Troubleshooting - Abicor Binzel xFUME VAC ADVANCED Mode D'emploi

xFUME VAC ADVANCED

10 Troubleshooting

DANGER
Risk of injury and device damage when handled by unauthorised persons
Improper repair work and modifications to the product may lead to serious injuries and damage to the device. The
product warranty will be rendered invalid if work is carried out on the product by unauthorised persons.
• Only qualified personnel are permitted to perform work on the device or system.
CAUTION
• Suitable safety measures must be taken before performing maintenance and cleaning work.
• Maintenance and cleaning work must only be carried out on the extraction system in areas with locally filtered forced
ventilation.
• Always wear your personal protective equipment when performing maintenance and cleaning work.
• Personal protective equipment consists of protective clothing, safety goggles, a class P3 respiratory mask, protective
gloves and safety shoes.
Please observe the attached 'Warranty' document. In the event of any doubts and/or problems, please contact your retailer
or ABICOR BINZEL.
NOTICE
• Consult the documentation for the welding components.
Fault
No complete fume detection.
Extraction volume too low.
External extraction system does not start.
Dust escapes from the dust collecting
drawer.
Filter cleaning does not work.
Tab. 6 Troubleshooting
BAL.0731.0 • 2019-09-18
Cause
• Clean air outlet covered.
• Filter elements saturated.
• Extraction hose blocked.
• Extraction hose defective.
• Power supply defective.
• Electrical components defective.
• Carbon brushes defective
• Dust collecting drawer not properly
sealed.
• Dust collecting drawer full.
• Compressed air supply faulty.
10 Troubleshooting
Troubleshooting
• Keep the clean air outlet clear.
• Replace the filter elements.
• Clean the extraction hose.
• Replace the extraction hose.
• Check and replace if necessary.
• Check and install correctly.
• Empty the dust collecting drawer.
• Check and replace if necessary.
EN - 19