Disposal; Welding Dust En - Abicor Binzel xFUME VAC ADVANCED Mode D'emploi

xFUME VAC ADVANCED

12 Disposal

12.1 Welding dust
All welding dust collected must be disposed of in accordance with local regulations.
12.2 Materials
This product is mainly made of metallic materials, which can be melted in steel and iron works and are thus almost infinitely
recyclable. The plastic materials used are labelled in preparation for their sorting and separation for later recycling.
12.3 Consumables
Oil, greases and cleaning agents must not contaminate the ground or enter the sewage system. These substances must
be stored, transported and disposed of in suitable containers. Please observe the relevant local regulations and disposal
instructions in the safety data sheets specified by the manufacturer of the consumables. Contaminated cleaning tools
(brushes, rags, etc.) must also be disposed of in accordance with the information provided by the consumables'
manufacturer.
The disposal of dust collecting bags and disposal bags is subject to special waste regulations. The dust must not enter sewage
systems or be disposed of together with normal household waste. Please observe the local and official regulations.
12.4 Packaging
ABICOR BINZEL has reduced the transport packaging to the necessary minimum. The ability to recycle packaging
materials is always considered during their selection.
BAL.0731.0 • 2019-09-18
Equipment marked with this symbol is covered by European Directive 2012/19/EU
on waste electrical and electronic equipment (WEEE).
• Electrical and electronic equipment must not be disposed of with household
waste.
• Electrical and electronic equipment must be collected separately and recycled in
an environmentally friendly manner.
• Please observe the local regulations, laws, provisions, standards and guidelines.
• Your local authority can provide you with information about the collection and
return of electrical and electronic equipment.
• To dispose of the product correctly, it must first be disassembled. Please note the
following information:
 11 Disassembly on page EN- 20
12 Disposal
EN - 21