Attaching The Welding Torch's Extraction Hose En; Attaching The Compressed Air Hose En - Abicor Binzel xFUME VAC ADVANCED Mode D'emploi

6 Putting into operation
NOTICE
• The extraction system must be at least 1.0 m away from the wall.
• Select a location that enables a short and straight extraction hose feed and prevents it from entering the employee's
space of movement.
• Protect the components from rain and direct sunlight.
• Only use the device in dry, clean and well-ventilated rooms.
 Fig. 2 Functional description on page EN- 10
1 Position the extraction system appropriately and lock the castors (4).
6.2 Attaching the welding torch's extraction hose
NOTICE
• A maximum of two fume extraction torches (1) can be connected.
1
4
1 Air intake fittings
Fig. 3 Attaching the welding torch's extraction hose
1 Connect the extraction hose (4) to the air intake fittings (1) on the extraction system (2).
6.3 Attaching the compressed air hose
 Fig. 5 Control elements/ports on page EN- 15
1 Screw in the compressed air connector, including the seal (included in the scope of delivery).
2 Attach the compressed air hose to the compressed air connector (8).
EN - 12
2
3
2 Extraction system 3
xFUME VAC ADVANCED
Fume extraction torch 4
BAL.0731.0 • 2019-09-18
Extraction hose