CAME ZLX24SA Mode D'emploi page 97

Removing obstacles
If an obstacle is detected via the AST control on the board or by a safety edge input, the [Remove obstruction] function inverts
the gate leaf far enough to free the obstruction, then it stops.
Confi guration>
Functions
B1-B2 output
Confi gure the contact.
Confi guration>
Functions
Hold-to-run
With the function active, the operator stops moving (opening or closing) when the control device is released.
When the function is active, it excludes all other control devices.
Confi guration>
Functions
Automatic closure
Set the time before automatic closure, once the opening travel end point has been reached or once the photocells have
caused a partial stop [C3].
The function does not work if any of the safety devices are triggered when an obstacle is detected, after a
complete stop, during a power outage or if there is an error.
Confi guration>
Times
Automatic closing after either partial or pedestrian opening
Set the time before automatic closure after a partial opening command has been performed or after the photocells have
caused a partial stop [C3].
The function does not work if any of the safety devices are triggered when an obstacle is detected, after a
complete stop, during a power outage or if there is an error.
Confi guration>
Times
M1 opening delay time
Adjust the delayed opening of the fi rst leaf compared to the second.
Confi guration>
Times
M2 closing delay time
Adjust the delayed opening of the second leaf compared to the fi rst.
Confi guration>
Times
Removing obstacles
B1-B2 output
Hold-to-run
Automatic close
Automatic partial close
M1 open delay
M2 close delay
Deactivated (Default)
On
Bistable
Monostable: on from 1 to 180 seconds (Default 1)
Deactivated (Default)
On
Deactivated (Default)
From 1 to 180 seconds
Off
1 to 180 seconds (Default 10)
Off
1 to 10 seconds (Default 2)
Off
1 to 25 seconds (Default 2)