CAME ZLX24SA Mode D'emploi page 104

BUS device status
Show the status of all devices that can be connected to the BUS and managed by the fi rmware in use.
Key
<n> is the device number.
Information
Manoeuvre counter
View the number of total or partial operator manoeuvres (after maintenance).
The number of manoeuvres is the number shown multiplied by 100.
Information
Confi gure maintenance
Set the number of manoeuvres the operator can perform before a maintenance warning signal is generated.
The warning is displayed as an [Maintenance required] message and signalled by 3 + 3 fl ashes every hour on
the device connected to the 10-5 output.
Information
Maintenance reset
Reset the number of partial manoeuvres.
Information
BUS device status
Manoeuvre counter
Confi gure maintenance
Maintenance reset
BUS photocells <n>
<n> from 1 to 8
The status shown may be:
OK
Not communicating
Safety device active
BUS selector <n>
<n> from 1 to 7
The status shown may be:
OK
Not communicating
BUS fl ashing beacon <n>
<n> from 1 to 2
The status shown may be:
OK
Not communicating
Total manoeuvres
Manoeuvres performed since the operator was installed.
Partial manoeuvres
Manoeuvres carried out after the last maintenance.
Deactivated (Default)
1X100 to 500X100
Confi rm? NO
Confi rm? YES