CAME ZLX24SA Mode D'emploi page 100

<Signal error> BUS fl ashing beacon
Set the colour of the BUS fl ashing beacon in the event of an error signal.
The warning light is activated after sending a command for movement.
The function only appears if there is a BUS fl ashing beacon connected.
Confi guration>
Manage lights>
BUS fl ashing beacon
Signal maintenance
Set the colour of the fl ash on enabled BUS devices (fl ashing beacons and selectors) when maintenance is necessary. With the
function activated, these devices will signal that maintenance needs to be carried out at the start of each manoeuvre.
Maintenance must be confi gured [Function Confi gure Maintenance].
The function only appears if there is a BUS fl ashing beacon or a BUS selector connected.
Confi guration>
Manage lights>
BUS device lights
CRP address
Assign a unique identifi cation code (CRP address) to the control board.
The function is used where there are multiple operators connected to the same communication BUS using the
CRP protocol.
Confi guration>
RSE communication
Signal error
Signal maintenance
CRP address
Deactivated (Default)
White
Yellow
Orange
Red
Purple
Blue
Light blue
Green
Deactivated (Default)
White
Yellow
Orange
Red
Purple
Blue
Light blue
Green
1 to 254 (Default 1)