CAME ZLX24SA Mode D'emploi page 96

Photocell BUS <n>
Associate a function with the photocell BUS <n> input.
<n> is between 1 and 8 and corresponds to the address set on the photocell dip-switch
Confi guration >
BUS safety devices
Command 2-7
Associate a command to the connected device on 2-7.
Confi guration>
Command inputs
Electric lock
Associate the electric lock release with a command.
Confi guration>
Functions
Closing thrust
When the leaves reach the closing limit-switch, the operator thrusts them towards the strike plate for a second.
Confi guration>
Functions
Thrust
Before every opening or closing manoeuvre, the leaves thrust inwards to release the electric lock.
The thrust motion is performed during opening or closing, depending on where the electric lock is active [see
function Electric lock].
Confi guration>
Functions
BUS Photocell 1
Photocell BUS 2
Photocell BUS 3
Photocell BUS 4
Photocell BUS 5
Photocell BUS 6
Photocell BUS 7
Photocell BUS 8
Command 2-7
Electric lock
Closing thrust
Thrust
Deactivated (Default)
C1 = Reopen while closing (photocells)
C2 = Reclose while opening (photocells)
C3 = Partial stop Only with [Automatic close] activated.
C4 = Obstacle standby (photocells)
C13 = Reopen while closing, with immediate stop once
the obstruction has been removed, even if the gate is not
in motion
C23 = Open command
C24 = Close command
Step-by-step (Default)
Sequential
Deactivated (Default)
From closed
From open
From open and closed
Continue
Deactivated (Default)
Minimum
Medium
Maximum
Deactivated (Default)
On