Additional Safety Notices; Before Use; Fitting The Connector Nipple; Lubrication - Parkside PDSS 16 A1 Traduction Des Instructions D'origine

Additional safety notices

■ If applicable, observe special work safety or
accident prevention regulations for the handling
of compressors and compressed air tools .
■ Ensure that the maximum permissible working
pressure specified in the Technical Data is not
exceeded .
■ Do not overload this tool – use this tool only
within the capacity range specified in the
Technical Data .
■ Use safe lubricants . Ensure sufficient ventila-
tion at the place of work . In case of increased
discharge:
check the compressed air tool and have it re-
paired if necessary .
■ Do not use this tool if you are distracted . Be
alert, watch what you are doing and use com-
mon sense when operating a compressed air
tool . Do not use tools when you feel tired or are
under influence of drugs, alcohol, or medica-
tion . A moment of inattention when operating
the tool can result in serious personal injuries .
■ Keep work area clean and well lit . Cluttered or
dark areas invite accidents .
■ Keep compressed air tools out of reach of
children .
■ Do not store outdoors or in damp environments
without protection .
■ Protect the compressed air tool, in particular
the compressed air connection and operating
elements against dust and dirt .
■ 20 │ GB │ IE
All manuals and user guides at all-guides.com

Before use

NOTE
► The compressed air tool may only be oper-
ated using cleaned, oil-atomised compressed
air and the maximum operating pressure of
6 .3 bar must not be exceeded on the ap-
pliance . The compressor must be fitted with
a pressure reducer to regulate the working
pressure .
► Wind Teflon tape
connectors .

Fitting the connector nipple

♦ Wrap the threads on the connector nipple
with Teflon tape
♦ Screw the connector nipple
inlet .

Lubrication

NOTE
► Regular lubrication is particularly important
to avoid friction and corrosion damage .
We recommend using a suitable special oil
for compressed air tools (e .g . Liqui Moly
compressor oil) .
–
Lubrication with mist oiler
A mist oiler (not supplied) continuously
and optimally lubricates the appliance
as a preparation stage after the pressure
reducer . A mist oiler gives off fine drops
of oil into the air flow and thus guaran-
tees regular lubrication .
–
Manual lubrication
If you do not have a mist oiler, lubricate
the tool before every use or longer work
sessions . Add 3–4 drops of pneumatic
oil into the connector nipple
around all threaded
.
into the air
.
PDSS 16 A1