Connecting A Dvd Player And Tv; Connecting A Tv With A Built-In Digital Tv Tuner - Pioneer VSX-C302 Mode D'emploi

03 Connecting your equipment

Connecting a DVD player and TV

Follow the instructions below, referring to the diagram, to
connect your DVD player and TV to the receiver.
1 Use a 3-pin AV cable to connect the DVD IN jacks
to a set of audio/video outputs on your DVD player.
This carries video and analog stereo audio signals from
your DVD player to this receiver.
2 Use a coaxial digital audio cable to connect the
DVD(TV/SAT) COAX jack to a coaxial digital audio
output on your DVD player.
This connection carries stereo and multichannel digital
audio.
If your DVD player doesn't have a coaxial digital audio out
VSX-C302

Connecting a TV with a built-in digital TV tuner

If your TV has a built-in digital TV tuner, you can connect
the digital audio output to this receiver to enjoy Dolby
Digital and DTS sound from digital TV broadcasts.
1 Complete step 3 in Connecting a DVD player and TV
above.
2 Use an optical digital audio cable to connect the
TV/SAT(DVD) OPT1 jack to an optical digital audio
output on your TV.
12
En
SPEAKERS
FRONT SURROUND
CENTER
R L R L
SUB
WOOFER
OUT
DIGITAL AUDIO OUT
VIDEO
L
AUDIO
R
OPTICAL
OPEN/CLOSE
STANDBY/ON
DVD Player
jack, it is possible to use an optical connection to the TV/
SAT(DVD) OPT1 jack. However, since by default this
input is assigned to the TV/SAT input, you will need to
reassign it to the DVD input before you can use it. After
connecting up everything else see Optical input setting
on page 33 for how to do this.
3 Use a video cable to connect the MONITOR OUT
video jack to a video input on your TV.
This connection carries video from this receiver to your
TV.
• If your TV has a built-in digital TV tuner, see also
Connecting a TV with a built-in digital TV tuner below.
ANTENNA
VIDEO
AM LOOP
FM UNBAL 75Ω
IN
OUT
IN IN IN OUT
CONTROL
L L L
DIGITAL IN
R R R
TV/SAT DVR/VCR DVD
DVD TV/SAT DVR/VCR
(DVD) (TV/SAT)
AUDIO
OPT1 OPT2 COAX
TV
AC IN
MONITOR
OUT
VIDEO