Resetting The System; Default Receiver Settings - Pioneer VSX-C302 Mode D'emploi

Using other functions

Resetting the system

Use this feature to reset the system to its factory default
settings.
RECEIVER
DISC NAVIGATOR
ROOM SETUP
1 Press RECEIVER.
2 In standby, press ROOM SETUP and SYSTEM
SETUP at the same time.
The display prompts you to confirm.
3 Within 5 seconds, press
The display shows OK?.
4 Within 5 seconds, press
The receiver should now be reset.
Note
• If the receiver is disconnected from the power outlet
for more than a month it will reset to the default
settings.
• The above reset doesn't affect the presets that you
have programmed into the remote control (see Using
the remote control with other components on
page 36).
SYSTEM SETUP
TUNE
TUNE
.
.

Default receiver settings

The table below shows the factory default settings. When
you reset the system, the receiver reverts to these
defaults (see Resetting the system above).
Setting type Default setting
Input DVD
– – – dB (no sound)
Master volume
AUTO
Listening mode
STEREO
Listening mode (w/
headphones)
Sound mode OFF
OFF
Dialog
Virtual Surround Back OFF
Input signal select AUTO
Speakers (Front, Automatically sensed
Center, Surround)
Setting
200 Hz
Subwoofer setting
LFE Attenuator 0 dB
Front speaker distance 10 ft.
10 ft.
Center speaker
distance
Surround speaker 10 ft.
distance
Dynamic Range OFF
Control
Dual Mono ch1
Input Attenuator OFF (all inputs)
DVD(TV/SAT) COAX DVD
jack assignment
TV/SAT(DVD) OPT1 TV/SAT
jack assignment
Channel levels Front: 0 dB
Center: 0 dB
Surround: 0 dB
Subwoofer: 0 dB
Room Setup M / MID
SR+ OFF
Note
• The default settings for the remote control to control
other components can be found in Using the remote
control with other components on page 36.
Page ref.
Page 26
(all inputs)
Page 26
(all inputs)
Page 27
Page 27
Page 27
Page 30
Page 32
Page 32
Page 33
Page 33
Page 33
Page 33
Page 33
Page 33
Page 33
Page 33
Page 33
Page 35
Page 24
Page 34
08
31
En