Operating Other Pioneer Components With This Unit's Sensor; Plugging In The Receiver - Pioneer VSX-C302 Mode D'emploi

Connecting your equipment
Operating other Pioneer components
with this unit's sensor
Many Pioneer components have CONTROL jacks which
can be used to link components together so that you can
use just the remote sensor of one component. When you
use a remote control, the control signal is passed along
the chain to the appropriate component.
Note that if you use this feature, make sure that you also
have at least one set of analog audio jacks connected to
another component for grounding purposes.
1 Decide which component you want to use the
remote sensor of.
When you want to control any component in the chain,
this is the remote sensor that you will point the remote
control at.
2 Connect the CONTROL OUT jack of that
component to the CONTROL IN jack of another
Pioneer component.
Use a cable with a mono mini-plug on each end for the
connection.
3 Continue the chain in the same way for as many
components as you have.
Tip
• You can also set up the supplied remote to control
other components in your system (both Pioneer and
non-Pioneer). See Using the remote control with other
components on page 36 for how to do this.
VSX-C302
CONTROL
IN
ANTENNA
AM LOOP FM UNBAL 75Ω
SPEAKERS
FRONT SURROUND
CENTER
R L R L
DIGITAL IN
TV/SAT DVR/VCR DVD
SUB
(DVD) (TV/SAT)
WOOFER
COAX
OUT OPT1 OPT2

Plugging in the receiver

Only plug in after you have connected all your
components, including the speakers.
Caution
• Handle the power cable by the plug. Do not pull out
the plug by tugging the cable and never touch the
power cable when your hands are wet as this could
cause a short circuit or electric shock. Do not place
the unit or a piece of furniture, etc., on the power
cable, or pinch the cable. Never make a knot in the
cable or tie it with other cables. The power cables
should be routed such that they are not likely to be
stepped on. A damaged power cable can cause a fire
or give you an electrical shock. Check the power
cable once in a while. When you find it damaged, ask
your nearest Pioneer authorized service center or
your dealer for a replacement.
1 Plug the supplied power cable into the AC IN
socket on the back of the receiver.
2 Plug the other end into a power outlet.
CONTROL
OUT IN OUT
VIDEO
IN
OUT
IN IN IN OUT MONITOR
CONTROL
OUT
L L L
R R R
DVD TV/SAT DVR/VCR
AUDIO
AC IN
03
19
En