Using Other Functions; Selecting The Input Signal Type; Using The Sleep Timer - Pioneer VSX-C302 Mode D'emploi

08

Using other functions

Chapter 8
Using other functions

Selecting the input signal type

The DVD, TV/SAT, DVR/VCR and FRONT inputs all have
both analog and digital jacks. You can select the type of
signal to be used in each case. The input signal type for
the current input is indicated in the display: ANA
(analog), DIG (digital).
The default AUTO setting is usually sufficient, letting the
receiver decide the most suitable signal type. However, if
you want to record from the or the DVR/VCR IN/OUT
jacks, then you should set the input signal type to analog.
• Press SIGNAL SEL to change the input signal type.
• SEL. AUTO – (default setting) Uses digital if available,
otherwise analog
• SEL. ANA – Uses the analog signal
• SEL. DIG – Uses the digital signal
Note
• When the FM/AM input is used, the display always
shows ANA (analog).
30
En
SIGNAL SEL

Using the sleep timer

The sleep timer automatically puts the receiver into
standby after the specified period of time.
RECEIVER
1 Press RECEIVER.
2 Press SLEEP to set the sleep timer.
Press repeatedly to select between:
• 90 MIN. – Switches to standby after 90 minutes
• 60 MIN. – Switches to standby after one hour
• 30 MIN. – Switches to standby after 30 minutes
The sleep timer indicator (
has been set.
Tip
• Press the SLEEP button once to view how much time
is left on the timer before shutdown. Each press after
that will cycle through the possible sleep time
lengths.
SLEEP
) lights when the sleep timer