Connecting A Satellite/Cable Receiver Or Other Set-Top Box - Pioneer VSX-C302 Mode D'emploi

Connecting your equipment

Connecting a satellite/cable receiver or other set-top box

Satellite and cable receivers, and terrestrial digital TV
tuners are all examples of so-called 'set-top boxes'.
1 Use a 3-pin AV cable to connect the TV/SAT IN
jacks to a set of audio/video outputs on the set-top
box component.
This carries video and analog stereo audio signals from
the set-top box component to this receiver.
2 Use an optical digital audio cable to connect the
TV/SAT(DVD) OPT1 jack to an optical digital audio
output on the set-top box component.
This connection carries stereo and multichannel digital
audio.
VSX-C302
If your set-top box component doesn't have an optical
digital audio out jack, it is possible to use a coaxial
connection to the DVD(TV/SAT) COAX jack. However,
since by default this input is assigned to the DVD input,
you will need to reassign it to the TV/SAT input before
you can use it. After connecting up everything else see
Coaxial input setting on page 33 for how to do this.
• If your satellite/cable receiver doesn't have a digital
ANTENNA
AM LOOP FM UNBAL 75Ω
SPEAKERS
FRONT SURROUND
CENTER
R L R L
DIGITAL IN
SUB TV/SAT DVR/VCR DVD
(DVD) (TV/SAT)
WOOFER
COAX
OUT OPT1 OPT2
DIGITAL OUT
STB (TV)
Note
audio output, omit step 2 above.
VIDEO
IN
OUT
IN IN IN OUT MONITOR
CONTROL
OUT
L L L
R R R
DVD TV/SAT DVR/VCR
AUDIO
VIDEO L AUDIO R
AV OUT
AC IN
03
13
En