Recalling Preset Codes; Resetting All Remote Control Settings - Pioneer VSX-C302 Mode D'emploi

Controlling other equipment
6 TV CONTROL buttons
Dedicated buttons for controlling your TV.

Recalling preset codes

The following steps show you how to recall preset codes
for each input and for the TV CONTROL buttons.
RECEIVER
DVD
TV CONTROL
1 Press RECEIVER and number button '1' at the
same time.
The LED starts blinking.
• To cancel the preset mode at any time press
RECEIVER.
• The remote control will also return to the previous
mode after one minute of inactivity.
2 Press the input select button you want to preset.
Select DVD, DVR/VCR, FRONT, or TV/SAT.
• To preset the TV CONTROL buttons, press TV
CONTROL .
The LED stops blinking and remains lit.
3 Use the number buttons to enter a 3 digit setup
code.
See Preset code list on page 40 for a list of all the codes of
different types of equipment.
The LED starts blinking again.
After entering a code, a power on/off command is
transmitted by the remote. If the component you want to
control can be switched on/off by remote, it should now
switch on/off.
If the other component fails to switch on/off, try another
preset code if there is one available.
4 Repeat process to assign preset codes for as
many components as you want.
TV/SAT DVR/VCR
FRONT FM/AM
RECEIVER
Note
• See Preset code list on page 40 for the components
and manufacturers available.
• The preset codes cover a wide variety of equipment,
however, there may be some models from a
particular manufacturer that do not work with any of
the available codes.
• With some components, not all functions are
controllable by this remote.
• Refer to VCR / DVD / LD player and DVD recorder
controls on page 38 and Cable TV / satellite TV / digital
TV / TV controls on page 39 for detailed information on
the function of individual buttons.

Resetting all remote control settings

This restores all presets to the factory defaults. See Using
the remote control with other components on page 36 for
the default remote settings.
• Press RECEIVER and number button '0' (zero) at
the same time. Keep them pressed for about 3
seconds.
The LED on the remote control blinks three times
indicating all the preset codes and the Remote Direct
setting have been reset to the factory defaults.
10
37
En