Connecting Other Audio Components; About The Wma9 Pro Decoder - Pioneer VSX-415 Mode D'emploi

Connecting up
Connecting other audio
components
The number and kind of connections depends
on the kind of component you're connecting.
Follow the steps below to connect a CD-R, MD,
DAT, tape recorder or other audio component.
1 If your component has a digital output,
connect this to a digital input on the receiver
as shown.
The example shows a coaxial connection to the
CD digital input jack using a coaxial digital
audio cable.
2 If necessary, connect the analog audio
outputs of the component to a set of spare
audio inputs on this receiver.
You'll need to make this connection for
components without a digital output, or if you
want to record from a digital component. Use a
stereo RCA phono cable as shown.
3 If you're connecting a recorder, connect
the analog audio outputs (REC) to the analog
audio inputs on the recorder.
The example shows an analog connection to
the CD-R/TAPE/MD analog output jack using
a stereo RCA phono cable.
Note
1 Note that you must connect digital components to analog audio jacks if you want to record to/from digital components (like
an MD) to/from analog components.
This receiver*
IN
1
OUT
IN
OPT
1
(TV/SAT)
IN
IN
ASSIGNABLE
COAX
DIGITAL IN
2
(CD)
OUT
COAX
1
(DVD
IN
/LD)
1
OPTICAL COAXIAL
DIGITAL OUT
CD-R, MD, DAT, Tape recorder, etc.
* The illustration shows the VSX-515, but
connections for the VSX-415 are the same.

About the WMA9 Pro decoder

VSX-515 model only
This unit has an on-board Windows Media
Audio 9 Professional (WMA9 Pro) decoder, so
it is possible to playback WMA9 Pro-encoded
audio using a coaxial or optical digital
connection when connected to a WMA9 Pro-
AUDIO
R L
FM UNBAL
AM
Ω
75
LOOP
CD
DVR/
VCR
VIDEO
IN
TV /
OUT
SAT
IN
DVD
MONITOR
/LD
OUT
FRONT
D V D
5.1CH
SUB
REC INPUT
WOOFER
IN
CD-R
PREOUT
/ TAPE
/ MD
PLAY
2 3
R L R
OUT
PLAY
AUDIO OUT AUDIO IN
03
ANTENNA
IN L
REC
®
15
En