Connecting Up; Making Cable Connections; Connecting Audio Components - Pioneer ELITE SX-A6MK2-K Mode D'emploi

02

Connecting up

Chapter 2:
Connecting up

Making cable connections

Make sure not to bend the cables over the top
of this unit (as shown in the illustration). If this
happens, the magnetic field produced by the
transformers in this unit may cause a
humming noise from the speakers.
Important
• Before making or changing any
connections, switch off the power and
disconnect the power cord from the AC
outlet.

Connecting audio components

The number and kind of connections depends
on the kind of component you're connecting.
Follow the steps below to connect a CD player,
tape recorder, turntable or other audio
component.
Note
1 iPod is a trademark of Apple Inc., registered in the U.S. and other countries.
8
En
Turntable
FM UNBAL
ANTENNA
AM LOOP
75
REC PLAY
OUT IN
12V
TAPE AUX1
TRIGGER
L
2
R
IN
OUT
REC PLAY
AUDIO IN/OUT
Tape deck, etc.
1 Connect the analog audio outputs of your
CD player (or other component) to the CD
inputs on this receiver.
Use a stereo RCA phono cable as shown.
• Connect any other components (such as
1
an iPod dock or a portable audio player) to
the AUX inputs in the same way.
3
CONTROL
XM IR
OUT
IN
IN OUT
SIGNAL
GND
L L
R R
CD PHONO
AUX2
This receiver
1
OUT
R L
AUDIO OUT
CD player, etc.
D6