Xm Radio Messages; Specifications - Pioneer ELITE SX-A6MK2-K Mode D'emploi

07 Additional information
Problem
The display is dark or off.

XM radio messages

Message Cause
The XM antenna is not connected.
ANTENNA
ANT ERR A short-circuit occurring in the antenna or
surrounding antenna cable.
The radio is being updated with the latest
UPDATING
encryption code.
NO SIGNAL The XM signal is too weak at the current
location.
The receiver is acquiring audio or program
LOADING
information.
The channel currently selected has stopped
OFF AIR
broadcasting.
CH – – – You have selected a channel that does not
exist, or that you have not subscribed to.
There is no artist name/feature, song/
program title, or channel category associated
with the channel at this time.

Specifications

Amplifier section
Power output specification is for when power
supply is 120 V.
• Continuous power output (both channels
driven at 20 Hz to 20 kHz)**
THD 0.2 % . . . . . . . . . . . . . . . . . . . . . 60 W + 60 W
THD 0.2 % . . . . . . . . . . . . . . . . . . . . . 45 W + 45 W
22
En
Remedy
• Press DIMMER on the remote control repeatedly to return to the default.
•
channels driven at 1 kHz)
THD 1.0 %, 4
THD 1.0 %, 8
•
20 Hz to 20 kHz, 25 W, 8
* Measured with DIRECT button switched on.
** Measured by Audio Spectrum Analyzer
Action
Check that the XM antenna cable is attached
securely.
Make sure that there is nothing unusual with
the antenna or antenna cable. Switch the
power off then back on again.
Wait until the encryption code has been
updated. Channels 00 and 01 should function
normally.
n/a
Wait until the information has been received.
Select another channel.
The receiver will automatically switch to
channel 001 (or the last selected channel).
No action needed.
FTC Continuous power output (both
Ω
. . . . . . . . . . . . . . . . . 53 W + 53 W
Ω
. . . . . . . . . . . . . . . . . 43 W + 43 W
Total harmonic distortion**
Ω
. . . . . . . . . . . . 0.05 %*