Switching Components On And Off Using The 12 Volt Trigger - Pioneer ELITE SX-A6MK2-K Mode D'emploi

06 Other connections
Switching components on and
off using the 12 volt trigger
You can connect components in your system to
this receiver through a 12 volt trigger. If you
turn the power to a connected component on,
the power to this receiver is also turned on.
This receiver will not turn on if you turn a
connected component off while this receiver is
1
currently off.
• Connect the 12V TRIGGER jack of this
receiver to the 12V trigger of another
component.
Use a cable with a mono mini-plug on each
end for the connection.
Note
1 When this system is already on, switching the connected component on will have no effect (switching the connected
component off will have no effect in any case).
20
En
12V
TRIGGER
FM UNBAL
75
R
SPEAKER 12V
TRIGGER