Publicité
Les langues disponibles
Les langues disponibles
Installation Steps
Peel back 2" (5 cm) of tape liner from each end of the visor
lateral flange
free end
rear
flange
3
free end
Gently press the exposed areas of tape against the surface and
verify position.
5
Apply pressure along all flanges to ensure proper adhesion of tape.
Retighten previously loosened mirror bolts and replace mirror cap.
7
Care and Cleaning
• Wash only with mild soap & dry with a clean cloth.
Congratulations!
You have purchased one of the many quality Auto Ventshade™ branded products offered by Lund International, Inc. We take the utmost pride in our
products and want you to enjoy years of satisfaction from your investment. We have made every effort to ensure that your product is top quality in
terms of fit, durability, finish and ease of installation.
Auto Ventshade
™
NOTE: Actual application may vary slightly from illustrations.
flange.
front
flange
Lund International, Ventshade Accessories Division
655 Raco Drive, Lawrenceville, GA 30045
800-241-7219 • Fax 770-339-5839 • Visit us at lundinternational.com
© 2005 Lund International, Inc. All rights reserved.
, the Auto Ventshade
TM
TM
Slide the front end flange of the visor under the previously loosened
mirror cap. Then align lateral and rear end flanges on the painted
slide under
mirror cap
free end
4
With the visor in its final position, remove the remaining tape liner
6
4 Piece Set
8
logo and the AVS
logo are trademarks of Lund International, Inc.
TM
Page 2 of 2
door frame.
by pulling on free ends.
The rear visor attaches with the same
preparation methods as the front visor.
Repeat Steps 1-8 for opposite side.
Publicité
