Accessories; Mounting Bracket - DeWalt DCE080RS Mode D'emploi

Accessories

GB
Recommended accessories for use with your tool are available for
purchase at your factory-owned local service center.
WARNING:
Since accessories other than those offered by D
have not been tested with this laser, use of such
accessories with this laser could be hazardous. To reduce
the risk of injury, only use D
recommended for use with this rotary laser.
If you need assistance in locating any accessory, please visit our
website www.2helpU.com

Mounting Bracket

Some laser kits include a mounting bracket, which can be used for
attaching the tool to a track or to a ceiling grid to aid in acoustical
ceiling installation. Follow the directions below for using the mounting
bracket.
CAUTION:
Before attaching the laser level to wall track or ceiling
angle, be sure that the track or angle is properly
secured.
1. Place the laser on the mounting base (Figure
5/8–11 screw hole on the tripod adapter (Figure
to the bottom of the laser with the hole (Figure
mounting base.
2. Turn the mounting knob (Figure
With the bracket's measuring scale (Figure
3.
loosen the clamp locking knob (Figure
jaws.
Position the clamp jaws around the wall track or ceiling angle
4.
and tighten the clamp locking knob (Figure
clamp jaws onto the track. Be sure that the clamp locking knob
is securely tightened before proceeding.
24
WALT
E
® accessories that are
WALT
E
) aligning the
P 5
), attached
G 1
) in the
P 6
) to secure the laser.
P 3
) facing you,
P 7
) to open the clamp
P 8
) to close the
P 8
CAUTION:
Always use a ceiling wire hanger or equivalent material,
in addition to the clamp locking knob, to help secure
the laser level while mounting it to a wall. Thread the
wire through the handle of the laser level. DO NOT
thread the wire through the protective metal cage.
Additionally, screws may be used to fasten the bracket
directly to the wall as a backup. Screw holes
) are located at the top of the bracket.
(Figure
P 9
5. Using the base leveling knob (Figure
position from the wall.
6. The tool can be adjusted up and down to the desired height for
working. While supporting the mounting base, loosen the locking
knob on the left side of the bracket (Figure
Turn the adjustment knob on the right side of the bracket (Figure
7.
) to move the laser level up and down to set your height.
P 4
Use the measuring scale (Figure
NOTE: It may be helpful to turn the power on and turn the
rotary head so that it puts a dot on one of the laser scales. The
D WALT target card is marked at 1–1/2" (38 mm), so it may be
E
easiest to set the offset of the laser to 1–1/2" (38 mm) below
the track.
Once you have positioned the laser at the desired height, tighten
8.
the locking knob (Figure
Construction Grade Rod
DANGER:
NEVER attempt to use a grade rod in a storm or near
overhanging electric wires. Death or serious personal injury
will occur.
Some laser kits include a grade rod. The D
marked with measurement scales on both sides and is constructed in
telescoping sections. A spring-loaded button actuates a lock to hold
the grade rod at various lengths.
The front of the grade rod has the measurement scale starting at the
bottom. Use this for measuring from the ground up when grading or
leveling jobs.
) approximate a level
P 2
).
P 1
) to pinpoint your mark.
P 7
) to maintain this position.
P 1
WALT Grade Rod is
e