Accessories - DeWalt DW089LR Mode D'emploi

The Battery Meter LEDs Flash
When all 4 LEDs continuously fl ash on the Battery
Meter this indicates that the unit has not been fully
powered off using the Power/Transport Lock switch
(Figure ). The Power/Transport Lock switch
F 2
should always be placed in the LOCKED/OFF position
when the laser is not in use.

Accessories

The laser is equipped with both 1/4 - 20 and 5/8 - 11
female threads (I) on the bottom of the unit (Figure
This thread is to accommodate current or future D
accessories. Only use D Walt accessories specifi ed
E
for use with this product. Follow the directions included
with the accessory.
WARNING:
Since accessories, other than those offered
by D Walt, have not been tested with this
E
product, use of such accessories with this
tool could be hazardous. To reduce the risk of
injury, only D Walt recommended accessories
E
should be used with this product.
If you need any assistance in locating any accessory,
please contact your nearest D WALT service center or
E
go to www.DEWALT.com.
Target Card
Some laser kits include a Laser Target Card (Figure
to aid in locating and marking the laser beam. The
target card enhances the visibility of the laser beam as
the beam crosses over the card. The card is marked
with standard and metric scales. The laser beam
passes through the red plastic and reflects off of the
reflective tape on the reverse side. The magnet at the
top of the card is designed to hold the target card to
ceiling track or steel studs to determine plumb and level
positions. For best performance when using the Target
Card, the D WALT logo should be facing you.
E
Laser Enhancement Glasses
Some laser kits include Laser En hancement Glasses
(Figure ). These glasses improve the visibility of
E
the laser beam under bright light conditions or over
long distances when the laser is used for interior
applications. These glasses are not required to operate
the laser.
CAUTION:
These glasses are not ANSI approved
safety glasses and should not be used while
operating other tools. These glasses do not
).
keep the laser beam from entering your eyes.
I
Walt
E
CAUTION:
To reduce the risk of serious injury, never stare
directly into the laser beam with or without
these glasses.
Ceiling Mount
The laser ceiling mount (Figure
more mounting options for the laser. The ceiling mount
has a clamp (Figure ) at one end which can be fi xed
J 2
to a wall angle for acoustic ceiling installation (Figure
). At each end of the ceiling mount is a screw hole
J 3
(Figure and ), allowing the ceiling mount to
J 4 J 5
be attached to any surface with a nail or screw.
Once the ceiling mount is secured, its steel plate
provides a surface to which the magnetic pivot bracket
(Figure ) can be attached. The position of the
J 6
) laser can then be fi ne-tuned by sliding the magnetic
D
pivot bracket up or down on the wall mount.
E
), if included, offers
J 1
19