DeWalt DCE080RS Mode D'emploi page 14

• Use appropriate personal protective equipment, including eye
GB
protection when working in a construction environment.
Tool Use and Care
• Do not use the tool if the switch does not turn it on or off. Any
tool that cannot be controlled with the switch is dangerous and
must be repaired.
• Store idle laser products out of the reach of children and do
not allow persons unfamiliar with the laser product or these
instructions to operate the laser product. Laser products are
dangerous in the hands of untrained users.
• Use only accessories that are recommended by the
manufacturer for your model. Accessories that may be suitable
for one tool, may become hazardous when used with another tool.
Batteries and Power
This D WALT rotary laser will accept all D
e
battery packs, but is built to best resist damage during a fall when
used with the following battery packs: All 1.5Ah and 2Ah D
volt lithium ion batteries.
Charging the Battery Pack
The battery pack is not fully charged out of the carton. You need to
use a D WALT 18 volt charger to charge the battery pack before you
e
can use the rotary laser.
• Be sure to read all safety instructions before using your charger.
WARNING:
DO NOT attempt to charge the battery pack with any
chargers other than the ones listed in this manual. The
charger and battery pack are specifically designed to work
together.
WARNING:
Carefully follow all instructions and warnings on the battery
label and package and accompanying Battery Safety
Manual.
Slide the battery pack into the charger as described in the
1.
Battery Safety Manual.
2. Wait until the battery pack is fully charged.
3. Slide the battery pack out of the charger.
14
NOTE: When ordering replacement battery packs, be sure to include
the catalog number and voltage.
Installing the D
Removing the Battery Pack
WALT 18 volt lithium ion
e
WALT 18
e
Storing Battery Packs
• The best storage place is one that is cool and dry, and away from
• Long storage will not harm the battery pack or charger. Under
WALT 18V Battery Pack
e
Position the fully-charged D
1.
release button (Figure
D 1
right.
Press and hold down the release button (Figure
2.
battery pack.
3. Slide the battery pack all the way into the track on the side of
the laser (Figure ).
D 2
4. Release the button on the battery pack.
1. Press and hold the release button on the battery pack (Figure
).
D 1
2. Slide the battery pack out of the track on the laser.
Release the button on the battery pack.
3.
4. To recharge the battery pack, insert it into the charger, as
described in the Battery Safety Manual.
WARNING:
Batteries can explode or leak, and can cause injury or fire.
To reduce this risk, follow the instructions in the Battery
Safety Manual.
direct sunlight and excess heat or cold.
proper conditions, they can be stored for 5 years or more.
SAVE THESE INSTRUCTIONS FOR FUTURE USE
WALT 18V battery pack so the
E
) is facing away from you and to the
) on the
D 1