DeVilbiss Healthcare DV56 SleepCube BiLevel ST PAP Serie Mode D'emploi page 20

Blower Off Menus
Compliance information can be viewed without turning the CPAP on. With the blower OFF (display shows OFF), press the
left or right arrow keys on the keypad to scroll through the information.
Display Example
OFF
Serial Number
HD000005
Adherence Score
83% (25/30)
SmartCode
F6CD-37F-357R
SmartCode
3CCC-377D-7J7X
SmartCode 30-Day
DWY4-3DB7-DJ7L
SmartCode 90-Day
752TT-47DB-7DT7C
SmartCode
ZDN-79FK-K7H
SmartCode Data and Adherence Score Information
Your Healthcare provider may contact you to retrieve SmartCode data and Adherence Score information. To display the
SmartCode data, press the LEFT arrow key once. Use the UP arrow or DOWN arrow keys to change the SmartCode
reporting period. Press the LEFT arrow key again to display the Adherence Score.
NOTE–To ensure accurate SmartCode information, the CPAP should remain plugged in and powered during the day. Do
not unplug daily.
Definitions
Not all of the features in the table below are available in all models. Some are optional, and some depend on what your
physician and/or home care provider has selected. The table below shows the items you may see and describes the
feature associated with each item. Also, some features are only available in certain modes or with the DeVilbiss SmartLink
Therapy Management Module. These are noted in the 'Mode' column below. If you do not see some of these options, your
model or configuration does not support them.
Please note that the values displayed are examples only.
Display Example
OFF
P: 5.0
Heat:Off
–
P : 1 0 . 0 S T R R : 1 5
I / E : 1 : 1 . 0 ( 5 0 % )
EN - 20
Description
Blower OFF. The CPAP unit is plugged in to AC or DC power with the blower OFF.
Shows the serial number of the device.
Shows the maximum adherence achieved for any period of thirty consecutive days of
use within a ninety-day time frame. The score represents the percentage of days,
within thirty consecutive days, where usage met or exceeded the 'Usage Threshold.'
SmartCode data is used for therapy management reporting. Therapy information is
1-Day
encoded in a series of letters and numbers and includes a special character for error
checking to ensure accuracy. Use the UP arrow or DOWN arrow keys to change the
SmartCode reporting period. There are five levels of SmartCode data: 1-day, 7-day,
7-Day
30-day, 90-day and Usage. Use UP or DOWN button to change between levels.
Usage
Description
Blower OFF. The CPAP unit is plugged in to AC or DC power with the
blower OFF.
This is the default screen when the device is turned on. The actual
Auto
mask pressure and heater setting are shown. The displayed pressure
may vary slightly while breathing. If the heater system is not
connected, the heat setting will be blank.
Real time info screen. Top row shows measured pressure (P), Trigger
source (Spontaneous or Timed), breath state (dash in center of top
row goes high during inhale and low during exhale). Bottom row
shows I:E ratio and % inhale.
Mode
All
All
All
Bilevel
Modes
SE-DV56-1