Télécharger Imprimer la page

Renfert EASY view 3D Mode D'emploi page 46

Masquer les pouces Voir aussi pour EASY view 3D:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 52
CAUTION!
Danger of being temporarily blinded if lighting is turned on suddenly.
⇒ Disconnect the power supply from the head (20, Fig� 2)�
EN
⇒ Tilt head upwards�
⇒ Push in tab on the underside�
⇒ Pull protective glass out�
⇒ Clean/replace the protective glass�
⇒ Push in the protective glass until the tab latches in again�
When sliding the safety glass:
- Do not allow it to get wedged
- Do not bend
- Use a cloth to avoid fingerprints.
8.3
Removing the cable from the cable duct / guiding it into the cable duct
For various reasons – for example, when connecting an HDMI-Video-Recorder – it may be necessary to
remove cables from the cable duct on the support arm or insert new ones�
See also the illustrated instructions at the end of this manual�
The cable of the power supply of the head is integrated into the support arm and cannot be re-
moved.
8.3.1
Removing cables
⇒ With the exception of the power supply (20, Fig� 12-a), remove all connectors
from the head�
⇒ Pull the HDMI cable straight out of the back and then remove it from the retai-
ning clip�
⇒ Remove the cable duct from the support arm�
⇒ Remove the retaining clip�
⇒ Remove the cable tie at the foot end of the cable duct� Make sure that no ca-
bles are damaged�
⇒ Pull the desired cable out through the ribs of the cable duct�
8.3.2
Inserting cables into the cable duct
Two retaining clips are designed as an insertion aid for inserting new cables�
⇒ Place the cable duct on a flat surface.
⇒ Use the insertion aid to grab the cable already in the cable duct�
⇒ Push the insertion aid together completely�
⇒ With the tapered end first, push the insertion aid into the cable duct 3 or 4 ribs
deep�
⇒ Feed the plug of the cable to be fed through the insertion aid and press the
cable into the cable duct that has been opened by the insertion aid�
Make sure that the plug is inserted from the correct side.
⇒ Hold the cable duct securely behind the insertion aid�
⇒ Pull the insertion aid and plug of the cable to be fed through the cable duct to the other end� Make sure
that the plug does not slip out of the insertion aid�
⇒ Remove the insertion aid�
⇒ Pull the cables through so that they protrude about 20 cm past the cable duct on the side of the EASY
view 3D head so that the head is not hindered when it pivots�
⇒ On the opposite side of the cable duct, secure the cables to the cable duct with cable ties so they can-
not slip�
⇒ Clip all the retaining clips onto the cable duct and secure the cable duct to the support arm�
Retaining clips designed as an insertion aid fit on the upper part of the support arm, the other
clips go on the lower part.
⇒ Insert the cables into the head�
⇒ Plug the HDMI cable into the retaining clip and then plug it straight into the socket�
⇒ Reconnect the other side of the cables�
Multiple cables can also be fed through together�
- 20 -
Fig. 40
1.
2.
Fig. 41
Fig. 42

Publicité

loading