Renfert EASY view 3D Mode D'emploi page 44

7.1.2 Recording video
When the HDMI-Video-Recorder is connected, video sequences can be recorded on a connected storage
medium such as the USB stick� The screen data, which is sent from the head to the monitor, is recorded�
EN
Video sequences can be recorded in both 2D and 3D modes� In order to be able to view 3D video se-
quences at a PC later, a 3D-capable monitor and 3D glasses are required�
To record video sequences:
⇒ Press the REC button (56, Fig� 35) on the HDMI-Video-Recorder�
♦ Video recording starts�
♦ The signal LED (55, Fig� 35) turns red�
⇒ Press the REC button on the HDMI-Video-Recorder again�
♦ The video recording is stopped and the data is stored on the storage medium�
♦ The signal LED flashes red, the data is saved.
♦ The signal LED turns green and the HDMI-Video-Recorder is ready for recording again�
When the signal LED is red or flashing, the USB memory stick should not be removed, as the data
will not be stored correctly and data loss will occur.
7.1.3 Recording video with sound
With the included headset, comments can be added to the video sequences during recording�
To do so, the microphone of the headset must be connected�
⇒ Plug the microphone cable of the headset (pink plug) into the MIC IN connection (54, Fig� 35) (pink
mark)�
The green plug of the headset should not be plugged into the green LINE-OUT jack, otherwise a
constant, quiet noise will be audible.
In order to save the video with music, for example, an external audio source can be plugged into
the blue LINE-IN connection.
7.2 EASY view 3D HDMI-Splitter
With the EASY view 3D HDMI Splitter, a 3D or 2D video signal can be sent to a second Renfert 2D/3D
monitor� The signal is multiplied but remains unchanged� This can be used for training purposes, for ex-
ample�
For this purpose, the head is connected at the input of the HDMI-Splitter and one monitor is connected to
each of the two outputs�
When using a standard PC monitor, only a 2D display is possible�
For output on other 2D devices (e�g� TV, monitor, projector, beamer), the Easy View Converter 3D/2D
(see 7�3) is required�
7.2.1 Connect
The HDMI-DVI cable of the monitor must be replaced for the
included HDMI-HDMI cable.
The HDMI-DVI cable of the monitor must be replaced for the in-
cluded HDMI-HDMI cable� To replace the HDMI-DVI cable for the
included HDMI-HDMI cable, see Chapter 8�3 and the illustrated
instructions at the end of this manual�
After replacing the cable:
⇒ Insert HDMI-HDMI cable into the head and the HDMI-Splitter
input (58)�
⇒ Insert HDMI-DVI cable of monitors into HDMI-Splitter out-
put (59, 60)�
⇒ Connect power supply unit of HDMI-Splitter at power input (57)�
Ensure that the color coding is correct between the connection
cable and socket!
- 18 -
58
57
Fig. 36
59
60
Fig. 37