Renfert EASY view 3D Mode D'emploi page 37

Different parameters are stored for each object mode, including the individual image brightness� This can
be changed�
To do so:
⇒ Select the object mode to be modified (see Chapter 5.4).
⇒ Press the mouse wheel (B)�
♦ A setting bar appears, where the current image brightness is displayed�
⇒ Turn the mouse wheel to change the brightness�
♦ Darker ●
♦ The "zero position" corresponds to the factory setting�
5.5 Screen shot / still image
Using the foot switch, the monitor image can be frozen (still image) or also stored on the USB memory
stick (screen shot)�
5.5.1 Still image
⇒ Press the foot switch for more than 1 sec�
♦ The still image is displayed, meaning the monitor image is frozen�
While the still image is displayed, the following actions can be performed:
⇒ Briefly press the foot switch.
♦ The screen contents are saved to the USB stick as a screen shot (see Chapter 5�5�2)�
⇒ Press the foot switch for more than 1 sec�
♦ Switch back to the live image�
The following settings can be changed while the still image is displayed:
• Switch between 2D and 3D display�
• Switch of magnification between 15x and 20x.
5.5.2 Saving a screen shot
Screen shot are only saved as 2D images, even if the 3D display was set when the save operation was
performed�
⇒ Briefly press the foot switch.
♦ The screen contents are saved to the USB stick as a screen shot�
♦ The screen shot icon appears on the monitor�
♦ The file name is displayed on the monitor during the save operation.
♦ No other actions are possible during the save operation (approx� 5 sec�)�
The file name has the following format:
• IMGxxx�bmp
• xxx = sequential counter 000 to 999
If the USB memory stick is then connected to a PC, the file names can be changed as usual, for example,
to assign them to a customer�
5.5.3 Accessing the USB stick via a network
If the EASY view 3D head is connected to a local network via the network port (25, Fig� 2) and the net-
work extension cable (already inserted in the cable channel), the images (screen shots) of the USB stick
in the head can be accessed over the network�
Access can take place using free FTP transfer programs (for example, FileZilla), or directly via the WIN-
DOWS Explorer or the Apple browser, Safari�
⇒ Plug in the network cable into the cable jack at the end of the network extension cable and connect it to
a switch or router� This network cable is not included in the scope of supply�
⇒ Move the mouse and note the IP address and host name�
♦ The IP address and host name are displayed at the bottom of the screen:
IP address:
Host name:
From version 2.001:
see sections 5.7 and 5.7.1. for information on IP address and hostname.
Access via a FTP transfer program
Depending on the FTP transfer program used, you will need to enter the host name and/or the
IP address� When asked for a user name, enter "Renfert"; a password is not required and can be ignored�
● ● Brighter
ftp://XXX�XXX�XXX�XX
ftp://Renfert@EV3D_xxxx (xxxx: 4-digit number, device-specific)
- 11 -
● ● ●
EN