Renfert EASY view 3D Mode D'emploi page 36

5.2 Adjusting the monitor
In most cases, the monitor can be used with its basic settings�
EN
5.3 Set up
There are two options for focusing the image:
• Coarse adjustment by moving the head with the support arm�
• Fine adjustment through height adjustment (6, Fig� 1)�
The amount of force required for the movement of the support arm, head and height adjustment can be
adjusted using the fastening and clamping screws, see Chapter 5�4�
The following procedure is recommended:
⇒ Align the head parallel to the table�
⇒ Place the object on the desk pad within the cone of light�
⇒ Set the head to the middle of the height adjustment�
⇒ Set the head on the support arm so that the object can be seen on the monitor and if necessary adjust
the height adjustment�
This allows you to quickly correct the focus for objects with different heights�
5.4 System settings
The current settings of the system are displayed on the monitor at the bottom left�
As soon as the mouse is moved, the monitor displays the available settings and with which element of the
mouse the setting can be changed�
2D/3D representation
⇒ Left mouse button (A)
♦ Switch between 2D and 3D
display
In addition, the current IP address and the host name of the EASY view 3D head are displayed (see
Chapter 5�5�3)�
5.4.1 Object modes – adjusting the brightness of the image
The object modes are customized for different materials of the respective objects:
• S:
• C:
• M:
• Neutral (especially for delicate, detailed areas and transitions in crowns and bridges)
For the object modes S, C, M, image processing is performed internally, improving the image
quality with respect to reflections and color reproduction.
Magnification
(15x, 20x)
Changing the system settings
A
⇒ Mouse wheel (B) rotation
⇒ Press / rotate the mouse
Standard (for example, when working with dentures, waxes, etc�)
Ceramic
Metal
System settings
B
forward / backward
♦ Switch of magnification
between 15x and 20x
wheel (B)
♦ Adjust the brightness of an
object mode (see Chap-
ter 5�4�1)�
- 10 -
Object mode (ceramic, metal,
standard, neutral), see Chap-
ter 5�4�1�
C
⇒ Right mouse button (C)
♦ Switch object modes