Changing The Water In The Boiler; Filter-Holders - LaCimbali M34 SELECTRON Utilisation Et Installation

When the machine is blocked, a warning message appears
on the display: if the key corresponding to the requested
wash cycle is pressed (key
the display are followed, the wash cycle is performed and
the machine is no longer blocked.
For example, if there is a "coffee block", the following
message appears on the display:
GROUP 1 LOCKED
EXECUTE WASHING
The number of the "blocked group" blinks on the display
and depends upon the number of machine groups.

CHANGING THE WATER IN THE BOILER

Keep a hot water distributor key (12) pressed down for
approximately 5 seconds.
The following message will be displayed: "WATER
CHANGE". The water from the boiler will drain from the
hot water nozzle (8) (60 - 70% ca. of the total capacity).
Dispensing will stop automatically.
After the procedure, the machine will return to its normal

FILTER-HOLDERS -

1
Put a liter of cold water in a
suitable container and add
detergent.
4
Remove any residue with a sponge and rinse well with
cold water.
Block function
26) and the instructions on
2
If the coffee wash circuit key
message will be integrated as shown:
GROUP 1 LOCKED
EXECUTE WASHING
INSERT FILTER HOLDER
When the "INSERT FILTER HOLDER - GROUP 1" mes-
sage appears, the block message for Group 1 disappears.
The block messages for groups still to be washed appear
in alternation.
At this point, follow the steps on the previous pages for
the wash cycle.
5
A
the anchoring spring (A
18 EN
(26) is pressed, the previous
GROUP 1
12
8
3
Soak the filters and the
for about 15 minutes.