Use; Day-To-Day Operation; Manual Powering; Automatic Switch Off / Switch On - LaCimbali M34 SELECTRON Utilisation Et Installation

"Before setting the machine at work, make sure that:
• the main electric power switch is on;
• the mains water cock has been turned on".

MANUAL POWERING

Press the luminous main switch (1) to turn on the machine.
The the key LEDs light up and the following message will
appear on the display (16):
12 March
wednesday
If the water level in the boiler is lower than the minimum
this phase, the icon will appear in the lower left hand
corner of the display.
The preset working pressure must be reached before the
machine is ready for use.
If any dispensing key is pressed during this phase, the
following message will appear on the display:
12 March
wednesday
MACHINE COLD
PLEASE WAIT

AUTOMATIC SWITCH OFF / SWITCH ON

The machine can be set to switch off and switch on at
programmed times. Consult the "Service time menu"
chapter to set the "ON Time" switch-on time and the "OFF
Time" switch-off time.
When a service time is set, the machine automatically
switches off at the programmed time. During the automatic
switch-off phase, the following message will appear on the
display:
12 March
wednesday
MACHINE OFF

USE

10. Day-to-day operation

2014
15:15:04
2014
15:15:04
2014
15:15:04
9 EN
ON
1
The machine is ready for use when the display (16) indicates
the set working pressure and the icon
is no longer shown on the display:
12 March
wednesday
Note. When the machine is working in the automatic on/
off function do not use the general switch (1) to switch off
the machine. If this happens, the machine will not be able
to switch on again automatically.
The machine switches on automatically at the programmed
timed. The messages displayed and the operations per-
formed by the machine are the same as those described
in the paragraph "MANUAL POWERING".

ENERGY SAVING STANDBY

When the machine is switched off, it can be set to the
ENERGY SAVING mode.
When this function is enabled, the machine resistance is
not completely disabled and keeps the boiler pressure at
0.2 bar.
Please consult the chapter "Service time menu" for setting
this function.
16
2014
15:18:12