Network Setup; Wired Network Setup - HP Photosmart C6200 All-in-One Série Guide D'utilisation

2

Network setup

This section describes how to connect the HP All-in-One to a network and how to view
and manage network settings.
If you want to:
Connect to a wired (Ethernet) network.
Install the HP All-in-One software for use in a
networked environment.
Add connections to more computers on the
network.
Change the HP All-in-One from a USB
connection to a network connection.
NOTE: Use the instructions in this section if
you first installed the HP All-in-One with a USB
connection, and you now want to change to an
Ethernet network connection.
View or change the network settings.
Find troubleshooting information.

Wired network setup

This section describes how to connect the HP All-in-One to a router, switch, or hub using
an Ethernet cable and how to install the HP All-in-One software for a network connection.
This is known as a wired or Ethernet network.
To set up the HP All-in-One on a wired
network, you need to do the following:
First, collect all of the required materials.
Next, connect to a wired network.
Finally, install the software.
See this section:
"Wired network setup" on page 9
"Install the software for a network connection"
on page 11
"Connect to additional computers on a
network" on page 12
"Change the HP All-in-One from a USB
connection to a network connection"
on page 12
"Manage your network settings" on page 12
"Network troubleshooting" on page 28
See this section:
"What you need for a wired network"
on page 10
"Connect the HP All-in-One to the network"
on page 10
"Install the software for a network connection"
on page 11
Network setup 9