HP Photosmart C6200 All-in-One Série Guide D'utilisation page 13

1. On the control panel of the HP All-in-One, press Setup.
2. Press
The Network Menu appears.
3. Press
The View Network Settings Menu appears.
4. Do one of the following:
• To display wired network settings, press
highlighted, and then press OK.
This displays a summary of the wired (Ethernet) network settings.
• To print the network configuration page, press
Configuration Page is highlighted, and then press OK.
This prints the network configuration page.
Restore network defaults
You can reset the network settings to what they were when you purchased the
HP All-in-One.
1. On the control panel of the HP All-in-One, press Setup.
2. Press
3. Press
4. Press OK to confirm that you want to restore the network defaults.
Change advanced network settings from the control panel settings
The advanced network settings are provided for your convenience. However, unless you
are an advanced user, you should not change any of these settings.
Set link speed
You can change the speed at which data is transmitted over the network. The default is
Automatic.
1. Press Setup.
2. Press
The Network Menu appears.
3. Press
Press
4. Press
OK to confirm the setting.
• Automatic
• 10-Full
• 10-Half
• 100-Full
• 100-Half
Change IP settings
The default setting for the IP settings is Automatic, which sets the IP settings
automatically. However, if you are an advanced user, you might want to manually change
the IP address, subnet mask, or the default gateway. To see the IP address and subnet
mask of the HP All-in-One, print a network configuration page from the HP All-in-One.
until Network is highlighted, and then press OK.
until View Network Settings is highlighted, and then press OK.
until Network is highlighted, and then press OK.
until Restore Network Defaults is highlighted, and then press OK.
until Network is highlighted, then press OK.
until Advanced Setup is highlighted, and then press OK.
until Set Link Speed is highlighted, and then press OK.
to select the link speed that matches your network hardware, and then press
until Display Wired Summary is
until Print Network
Manage your network settings 13