Install The Software For A Network Connection - HP Photosmart C6200 All-in-One Série Guide D'utilisation

3. Connect the other end of the Ethernet cable to an available port on your Ethernet
router, switch, or wireless router.
4. Once you have connected the HP All-in-One to the network, install the software as
described in

Install the software for a network connection

Use this section to install the HP All-in-One software on a computer connected to a
network. Before you install the software, make sure you have connected the
HP All-in-One to a network.
NOTE:
sure that your computer is currently connected to these drives before installing the
software. Otherwise, HP All-in-One installation software might try to use one of the
reserved drive letters, and you will not be able to access that network drive on your
computer.
NOTE:
operating system, the amount of available space, and the processor speed of your
computer.
To install the Windows HP All-in-One software
1. Quit all applications running on your computer, including any virus detection software.
2. Insert the Windows CD that came with the HP All-in-One into the CD-ROM drive on
your computer and follow the onscreen instructions.
3. If a dialog box about firewalls appears, follow the instructions. If you see firewall pop-
up messages, you must always accept or allow the pop-up messages.
4. On the Connection Type screen, select Through the network, and then click
Next.
The Searching screen appears as the Setup program searches for the HP All-in-One
on the network.
"Install the software for a network connection" on page
If your computer is configured to connect to a series of network drives, make
Installation time can range from 20 to 45 minutes depending on your
Install the software for a network connection
11.
11